Carpenter Model 75 Compu-Strip®
Carpenter Model 75 Compu
-
Strip
®
•
Phone
: (315) 682-
9176 •
Fax
: (315) 682-9160
Website
: www.carpentermfg.com •
Revised June 10
th
, 2019
Page 57
number entry, pressing
will clear the field and allow re-entry of the number. Press
when finished.
Figure 4
-
15
: Model 75 Memory Number Entry Screen
If the memory number entered contains a cable program, the Model 75 recalls the setup
data into the run memory and this data is displayed on the run screen; processing of
cables can begin.
Note
: Always verify that the correct wire guide bushing is installed before attempting to
process cables with new strip data.
If the memory number entered is empty, the Model 75 will notify the operator that the
memory location is unused.
4
.
5
.
2 Memory STORE Mode
To store the current program (the strip data displayed on the run screen) to a memory
location, press the
key and position the blue data highlight cursor over
STORE
and press the
key. The Model 75 will prompt the operator for the memory number
to store the data in, and the current memory number will be displayed as in Figure 4-15
above.
