Carolina Attachments LLC.
Page 6
Swing Boom Cutter
March 2016
material, and similar protection on the
right side of the operator’s cab.
Make sure your
skid steer is in good working
condition. Follow the operating
instructions found in the manual that
accompanied your skid steer. Failure
to do so could result in Minor or
Serious Injury.
Unpacking Your
Shipment
Your attachment arrives from the
factory banded to a wooden pallet,
and requires no final assembly.
Careless
removal of the shipping bands that
secure the implement to the pallet
could result in Minor or Serious Injury.
Clear the area of all bystanders and
stand to the side when cutting the
bands with a pair of sheet metal
shears.
Using Your Implement
Connecting Cutter to
Skid Steer
Never enter the
area underneath the coupler or any
part of the attachment when it is in
the raised position to avoid an
accident that will result in Death or
Serious Injury.
Verify that the hydraulic hoses and the
wire harness are clear from the front
of the attaching plate on the
attachment and that the mounting
plate is free from dirt and debris.
When clear, move the skid steer to
proximity of attachment plate. Tilt skid
steer coupler forward to align coupling
point with the upper part on the
attachment plate and raise the coupler
slightly.
Connecting Coupler to Attachment
When the top edge of the coupler is
seated in the top part of the coupler
plate, roll the skid steer tilt function
back until the attaching plate is flat
against the skid steer coupler. Lock
down the coupler levers.
Wipe off any dirt
or dust from the male or female
hydraulic flat-face couplers with a
clean rag before attaching hoses, to
keep contaminants from entering the
hydraulic system.
Connect the cutter hydraulic hoses to
the auxiliary circuit connectors on the
skid steer. Connect the electrical
harness to the appropriate connector
on the skid steer.
Check the surrounding area for
bystanders and clear them before
starting the skid steer or attachment.
Before operating the attachment,
always visually inspect and verify that
the coupler lock pins are fully engaged
through the latch slots on the
attachment plate.
Check Coupler Lock Engagement
