Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1-877-722-8877 |
69
G SERIES USER MANUAL
6.0 ENERGY MANAGEMENT SYSTEM PROGRAMMING
6.0 Energy Management System Programming and Testing
The Energy Management System (EMS) has several programming functions and settings. These are accessed
through the On-Board User Interface (OBUI). Specific products will use a subset of the complete OBUI settings,
which will be covered in this manual’s sections specific to each product.
Certain combinations of settings can result in the system not meeting intended specifications
(such as ITE or SAE) or cause damage to the equipment. Contact Carmanah for guidance if
unfamiliar with system limitations.
Modifying settings can significantly affect the solar energy balance of the system, which could
result in reduced battery life and performance. Contact Carmanah to for more information about
sustainable settings in your location.
6.1 EMS On-Board User Interface Operation
Three buttons on the EMS OBUI are used to navigate and change settings and activate functions as required.
The “Up arrow”, “Down arrow”, and “set” button are used to scroll through menus, access and change settings,
and accept new settings.
Use the Up and Down
arrow buttons to scroll
through the menu.
Press and hold the “set”
button to edit a setting.
The display will blink
when the setting is ready
to edit.
Use the Up and Down
arrow buttons to adjust
the setting when in edit
mode.
Press and hold the “set”
button to accept the new
setting. The display will
flash 3 times to indicate
the setting has been
accepted.
EMS On-Board User Interface (OBUI)
