CARLO GAVAZZI VMU-C EM, Instruction Manual

Page: 59 / 126

VMU-C
VMU-C Instruction manual 59
3.3 VMU-P MODULE CONFIGURATION
if one or more VMU-
P modules are identified during the “auto-detection” procedure, the
system will display the screen shown below (for each VMU- M EM there may be no more
than 1 VMU-P module; VMU-C EM can manage up to 11 VMU-P modules).
The procedure for the auto-detection of the VMU-M EM scans all the devices existing on
the COM1 port, stores their position and displays the current configuration.
VMU-P module configuration mask
In the area marked by the dots the system will automatically display the information
concerning the source base module (VMU-C EM or VMU-M EM) and the location of the
VMU-P module within the system.
Specify for each module which temperature measurements shall be monitored
(Temperature of channel1, of channel 2 or both) and the type of sensor to be used
(Pt100 or Pt1000 probes, 3 wires or 2 wires).
For each module you can also enable (or disable) the measurements from the analogue
inputs and from the frequency input (pulse input).