49
© Carlo Gavazzi A/S
Leave 20 cm or 8 inches of extra wire for making the connections to the sensor� This extra wire not
only makes it easier to connect the sensors, but it also prevents stress to the connections due to
extreme radii�
Fig. 46
To mount the sensor to the back housing, press the two parts together and
turn the sensor counter-clockwise just a couple of cm (3/4 inch)� The edges of
the sensor must follow the edges of the back part to be completely mounted, like a bayonet mounting
configuration�
Fig. 47
Use the plastic retaining pin to unite the two parts�
Fig. 48
It is advisable to add
20 cm (8 in) of wire for
physical sensor connec-
tions�
Press the two parts
together and twist the
upper part 2 cm (3/4 in)
counter-clockwise so
that the edges on the
parts are aligned with
each other in a bayonet
style�
