Carlisle ms 8160 Series, Service Manual, Page: 18 / 29

12.9
4.6
Strength Marking
4.8 8.8 and 9.8
10.9
Max Torque Max Torque Max Torque Max Torque Max Torque
Ft/Lbs Ft/Lbs Ft/Lbs Ft/Lbs Ft/Lbs Diameter Wrench Size
M3 5.5mm 0.3 0.5 1 1.5 1.5
M4 7mm 0.8 1 2 3 4
M5 8mm 1.5 2 4.5 6.5 7.5
M6 10mm 3 4 7.5 11 13
M8 13mm 7 1 18 26 33
M10 16mm 14 18 37 55 63
M12 18mm 26 33 63 97 111
M14 21mm 37 55 103 151 177
M16 24mm 59 85 159 232 273
M18 27mm 81 118 225 321 376
M20 30mm 118 166 321 457 535
M22 33mm 159 225 435 620 726
M24 36mm 203 288 553 789 926
M27 41mm 295 417 811 1154 1353
M30 46mm 402 568 1103 1571 1837
GENERAL FASTENER TORQUE REFERENCE GUIDE
Check for powder accumulation within channels of
reciprocator and clean off with compressed air or vacuum,
as needed.
Using a blow gun, direct compressed air at the
reciprocator area.
Use a sweeping motion while starting at the top and
working downward.
As working downward, blow off automatic guns.
AREAS TO CLEAN AND INSPECT
Return To Contents
PA-19-04-R0 (02/2019) 18 / 29 www.carlisleft.com
MAINTENANCE
EN