Carl Valentin DPM IV, Service Instructions Manual

Page: 48 / 96

Mechanics (Replace Components) DPM IV
48 Service Instructions 05.19
5.15 Encoder
A
B
C
D
E
A
B
C
D
E
Figure 29
1. Unscrew the six countersunk screws and remove the top cover.
2. Unscrew the six countersunk screws and remove the rear cover.
3. Open dust cover or remove it by unscrewing four screws at the
hinges.
4. Remove the transfer ribbon.
5. Push the print carriage into an appropriate service position.
6. Remove the connector (A) on the back from the encoder (C).
7. Unscrew the two screws (D).
8. Remove the encoder (C) with the bracket (B) from behind from the
print carriage.
9. Clip out the encoder (C) of the bracket (B).
NOTICE!
The space is very cramped. If necessary, carefully use a
long electronic needle-nose pliers.
Removing the encoder