Carl Valentin COMPA II, Operating Manual

Page: 48 / 116

Function menu Compa II
48 Operating manual 03.20
6.3 Print Settings
Switch on the label printer and the display shows the main menu.
Press the key to access the function menu.
Press the key to select the menu Print settings .
Indication of print speed in mm/s (see chapter Technical Data, page
17). The print speed can be determined for each print order anew.
The setting of print speed affects also the test prints.
Indication of value to set the print intensity when using different
materials, print speeds or printing contents.
Value range: 10 %
… 200 %.
Step size: 10 %.
Press the key to move to the next menu item.
Examination if the transfer ribbon roll is to end or if the ribbon was torn
at the unwinding roll. the current print order is interrupted and an Error
Message appears at the printer display.
Off: The ribbon control is deselected, i.e. the printer continues without
an error message.
On, weak sensibility (default): The printer reacts at approx. 1/3
more slowly to the end of the transfer ribbon.
On, strong sensibility: The printer reacts immediately to the end of
the transfer ribbon.
Press the key to move to the next menu item.
Indication of initial point displacement in mm.
Displacement of the complete print in paper direction. With positive
values the print in paper direction starts later.
Value range: −30.0 … +90.0.
Press the key to move to the next menu item.
Displacement of the complete print transverse to the paper direction.
The displacement is possible only up to the edges of the printing zone
and is determined by the width of the focal line in printhead.
Value range: −90.0 … +90.0.
Press the key to move to the next menu item.
Indication of value to which the last label of a print order is moved
forward and is moved back to the beginning of label at a new print
start. Labels can be torn off after terminating the print order without a
label loss by tearing up.
Default value: 13 mm.
Value range: 0
… 70.0 mm.
Speed
Contrast
Ribbon control
Y displacement
X displacement
Tear-off