9
Before mounting the tail the bottom
wing should be installed.
Collect the following items
(1) Fuselage
(1) Bottom wing
(2) Wing dowels (8mm x 40mm)
(2) 1/4” x 2” wing bolts
(1) Trailing edge reinforcement plate. 1/8” ply.
1.
Epoxy the dowels in the pre-drilled holes in the
leading edge
2.
Lay the 1/8” plywood plate over the holes in the
trailing edge of the wing and insert the wing bolts
for alignment. Use a pen and mark the outline of
the plate on the covering.
3
.
Remove the covering by cutting about 1/8”
inside the line you just drew. Be careful and
do not cut into the wood.
4.
Use epoxy and glue the plate in place. Insert
the wing bolts to make sure the holes are
aligned and clamp into place till dry.
5.
Set the wing in place with the dowels inserted
into the bulkhead and install the wing bolts.
Bottom Wing Mounting
Caution:
Do not glue the bolts!
