Carguard G 7050, User Manual

Page: 14 / 88

14
G 2500 English
Digit Corresponding button
1
Please press
2
Please press
3
Please press
4
Please press
Attention! Siren will chirp according to PIN code first new digit for confirmation.
1.
Please press ”Override” button 1 time to reset PIN code's second digit.
2. Use the remote to enter PIN code's second digit
Digit Corresponding button
1
Please press
2
Please press
3
Please press
4
Please press
Attention! Siren will chirp according to PIN code second new digit for confirmation Attention!
Please remember new PIN code digits
26. Programmable remotes
System memory can save datas from up to 4 remotes ,you will need to
：
1. Turn off ignition.
2.
Press ”Override” button 7 times.
3. Turn on ignition.Siren will chirp 7 times to confirm that you have entered setup process of this feature.
Press both and of new remote together until the system chirps to confirm it has been
recored to the system memory,you may add another new remote using this procedure
（
1 chirp for first
new remote,2 chirps for second new remote,3 chirps for third new remote, 4 chirps for fourth new remote
）
Attention! Datas of lost remotes will be erased from system memory,therefore we suggest you
should add all the desired remotes to the system in advance.
Attention! If you do not complete the procedure within 6 seconds,the system will exit this setup
process. .
27. Messages of programmable remotes
You are able to check the remote quantity in the system of Carguard G 7050 for safety reason .To use
this feature,you will have to
：
1. Turn off ignition
2. Press on the remote
3. The number of antenna's LED indicator flashes reflects the quantity of equipped remotes.
28. Sensor status messages
Please turn on ignition before you check the sensor status.By activating the sensor that you desire to
examine its condition
（
Example:Open the car door
）
if the sensor is functioned properly ,the LED of antenna
will flash for confirmation..