CareFusion Pyxis MedStation 4000, User Manual, Page: 47 / 246

Devices
Pyxis MedStation 4000 System Console User Guide 37
Taking a device in or out of service
The following procedure explains how to take a station out of service or put it
back in service. If you take a device out of service, all communication between the
console and the device is stopped after the device is out of service.
1. Select
System Setup > Devices
.
2. In the Devices dialog box, select the device whose status you want to change
and click
Edit
.
3. In the lower-right corner of the Editing Device dialog box, click
In Service/Out
of Service
.
4. When the confirmation message appears, click
Yes
to continue.
5. If the devices in service, a message appears asking “Are you sure you want to
change the device status to Out of Service?”
If the device is out of service, the popup message asks “Are you sure you want
to change the device status to In Service?”
6. Click
Yes
to continue.
7. On the Devices dialog box, the Status column indicates a pending status and
then a final status within 10 seconds of clicking the
In Service
or
Out of
Service
button.
If the device was in service, the Status changes to PendingOutOfSvs . If the
device was out of service, the Status changes to PendingInSvs .
8. When the confirmation message appears, click
OK
.
NOTE
Take a station in or out of service only under the direction of a CareFusion
representative.