CareFusion Infant Flow LP SiPAP, Service Manual, Page: 27 / 96

Service Manual
17
675-120 Rev. G
Alarm Conditions
Audible and visible alarm indications are given to alert the Operator to specified
conditions that affect the operation of the unit. The electronic alarm limits are
automatically set after two minutes without Operator inputs but the Operator can
manually set the alarm parameters for certain conditions if required. The IFSD has
the following alarms:
•
an audible Whistle which sounds a constant tone when the gas imbalance
limits are exceeded.
•
an audible Alarm which sounds a constant tone or two different intermittent
tones; medium or high level (medium level sounds beep.beep.beep every 15
seconds and high level sounds beep.beep.beep beep beep every 10 seconds).
•
a visual Warning Bar which flashes red continuously, flashes intermittently or
comes on continuously.
•
an Alarm Button on the touch screen status bar which flashes continuously.
Other indications are given to indicate the status of the condition. Refer to Table 2 for
alarms and indications for specified conditions.
Diagnostic Screen
A diagnostic screen is provided for low level calibration, test procedures for valves
and an error log. Figure 5 shows the screen display.
Labeling of Diagnostic screen
will be the same regardless of configuration.
Figure 5: Diagnostic Screen