SOKIII
&
S
UMMIT
Service
Manual
Carefree of Colorado
8
052520-301r1
C
OVER
B
UMPERS
The cover is shipped with bumpers to prevent rattling. Quantities are two (2) for units under 10"; three (3)
for units 10' to 14' and five (5) for units 14' and longer.
To replace missing or damaged bumpers:
1. In the positions shown, fully press the first round section into the inner slot. This is the same slot that
the latch springs or cover attach screws mount in. Please note the orientation of the bumper.
Tip: Press one end of the bumper into the slot. While holding the bumper in place, gently stretch the
bumper. This will temporarily make the diameter smaller and easier to press into the slot.
2. Stretch the bumper around and press the second round section into the outer slot.
4”
(typ)
4”
(typ)
1/4 Deflector Length
(typ)
0” - 3/4”
Covers 12’ and Longer and XL Cover Halves
Center Bumper Used On
10’ - 14’ Lengths Only
Covers Under 12’
(Cover Shown in Raised Position)
SOK3039
Bumper
Inner Slot
Outer Slot
Manual
Compliments
of
Northwest
RV
Supply
Printed
From
http://www.nwrvsupply.com
Table of Contents
