CARDIOSTRONG TR70i, Assembly And Operating Instructions Manual

Page: 13 / 60

TR 70i
13
Error
code
Troubleshooting
N/A The LED on the start button glows faintly, other LEDs are not on: The machine is in power
saving mode. Hold the START button for one second.
N/A The console display is fluctuating or does not light up: Check if the treadmill is correctly
connected to the power supply. Turn the power switch off and back on. Safety key is plug-
ged in. Check all cable connections for correct connection. If the problem is still occurring,
please contact customer service.
N/A The belt does not run in the middle during usage:
First check if the treadmill has a stable position, then follow the operating manual in regards
to tension and adjusting the belt (the deck).
N/A The motor appears to be overloaded or E1 appears after a few minutes of training:
The silicone applied to the deck and belt has dried out and the deck must be lubricated
again with silicone spray.
N/A The running mat slips during usage. The belt must be tensioned after a certain amount
of usage. Follow the belt tensioning and alignment in this manual.
N/A Heart rate fluctuates or is not recorded:
Check to see if your hands are moist, if all connections behind the console are correct and if
any cables are damaged. With a chest strap, check the battery status and make sure that all
electrodes are moist and correctly placed below the chest.
N/A Silicone symbol is illuminated on the console:
Lubricate the machine with 100% pure silicone. Then press speed down and START at the
same time until the symbol goes out.
2.4 Care and maintenance
The most important maintenance measure is taking care of the running belt. This
includes the adjustment, tensioning and lubrication of the running belt. Damage
caused due to a lack of care or negligence will not be covered by the warranty. Thus,
check for maintenance in regular intervals. Be extremely careful when adjusting and
tightening the belt, because a strong over or under tension may lead to damage. The
running mat is set properly in the factory before delivery. However, the running mat
may get out of place during transport.