A
B
C
E
F
G
J
I
1
6 ”
A
C or J
2
C or J
3
2X
E
4
B
I
5
LOOSEN AT TOP AND
BOTTOM OF GATE TO
ADJUST GATE WIDTH
2X
6
K
H
ONE-WAY
STOP BRACKET
OPTION
ASSEMBLY INSTRUCTIONS
1.
Install hinge bracket
(
A
) to wall (stationary
side of gate) using
Phillips screw (
C
)
beginning 6 ” above
floor surface. (Use
ruler on left edge of
this sheet to measure
from floor).
OPTION:
Long
screws (
J
) maybe be
used to attach gate to
stud through dry wall.
2.
Install second
screw (
C
) in
top of hinge
bracket
securing it to
the wall.
NOTE:
THIS SIDE OF GATE HAS
TWO (2) HOLES 22 INCHES APART.
3.
Insert eye bolts with nut and washer (
E
)
through gate into threaded inserts (
F
).
(side with two holes, 22 inches apart).
Use Allen wrench
to insure nuts are tight.
4.
Hang gate by inserting hinge rod (
B
), through top
of mounted hinge bracket (
A
), through both eye
bolts (
E
), and finally through bottom of hinge
bracket. To secure hinge, insert key ring (
I
) through
hole in end of hinge rod. Gate can be mounted at
angles up to 30 degrees.
5.
Use flat head screwdriver to loosen
bracket screws to adjust gate to fit
desired width and tighten bracket
screws. DO NOT OVERTIGHTEN.
6.
Mount latch assembly (
K
) to gate using 3/4” bolts with serrated
washers (
D
) and threaded inserts
(F)
. Attach wall mount for
latch assembly (
H
) up into part (
K
) that is now secure on gate.
Slide gate out to mark holes for (
K
) on attaching wall.
(*OPTIONAL ONE WAY BRACKET INSTALLED HERE) Then
attach the wall mount of latch assembly to wall using Phillips
head screws (
C
).
GATE IS RECOMMENDED FOR CHILDREN BETWEEEN 6 AND 24 MONTHS.
WOOD GATE - MODEL WG35
D
H
K
L
ONE-WAY
STOP BRACKET
OPTION
D
D
ONE-WAY
STOP BRACKET
OPTION
L
IF GATE IS INSTALLED AT TOP OF STAIRCASE:
Install one-way stop bracket (
L
) on one side of
wall mount latch to have gate open in only one
direction for maximum safety.
FOR OPENINGS 29.5” (75cm) - 49.25” (125cm)
SEE REVERSE
FOR GATE
OPERATION
INSTRUCTIONS
X4
F
F
F
G
(
G
) to assist in tightening
