•
Figure 7
•
Figure 8a
•
Figure 8b
8
3
If door has not yet been fitted, fit now
(refer to door fitting instructions) but
do not fit latches at this stage. If door is
already fitted, remove all latches now.
ENSURE DOOR IS CORRECTLY TENSIONED
AND LUBRICATED
4
Open door three quarters of full opening height.
5
Take the Autoglide track unit and operate
manual release lever (Figure 7) by pushing
towards drive carriage. This will disengage drive
carriage from Dymetrol tape inside the track.
Slide the carriage to a position approximately
305mm (12") from top of track.
6a
If door is fitted to a timber frame.
Offer track up to right-hand side of door
and slide spindle into shaped recess in top
of drive carriage (Figure 8a). Position top of
track 25mm (CD45) or 6mm (CD PRO) from
underside of top lintel (Figure 9). Ensure
spindle fits comfortably in recess with 1.0mm
clearance between end of spindle and carrier
housing (Figure 8b).
Screw track to side jamb using 3 off No. 8
×
1"
countersunk self tapping screws provided
(Figure 11) ensuring track is parallel to side
of door.
1.0 mm
Spindle
Recess
Drive
carriage