3
Fitting the track assembly
WARNING:
The spring is under extreme tension – follow instructions
carefully to avoid personal injury. If in any doubt at all consult a
qualified installer (see Yellow Pages for details).
NOTE:
If door is not yet fitted, fit door to opening only after completing stages
1
and
2
(refer to door fitting instructions). Do NOT fit latches at this stage.
30 mm
100 mm
Cut out
Side seal
Spring
anchor
bush
R/H (black)
cone pulley
Retaining pin
Apply
spanner
here
Runner
1
Cut out a 30mm
×
100mm rectangle in top
of right-hand side seal of door (looking
from inside garage) as shown in Figure 1.
NOTE:
Later doors already have this cut out.
2
Replace existing spindle on right-hand side
of door (looking from inside garage) with
special spindle supplied in accessory pack
as follows:–
a. Open door fully and remove screws from
centre of right-hand runner (Figure 2).
b. Close door fully, ensuring latch is
engaged. Grip right-hand (black) cone
pulley with spanner and by turning upwards
align holes in anchor bush and spring shaft.
Insert retaining pin supplied fully into hole
(Figure 3) – and remove spanner.
c. Remove right-hand side runner and
security block by removing screws at top
and bottom of runner (Figures 4 & 5).
•
Figure 3
•
Figure 1
•
Figure 2
6
IMPORTANT NOTE:
If you are fitting to a door supplied
with CD PRO gear use instructions supplied in item 15.