11
3
Fit eurolock handle as per door fitting
instructions and turn fully anti-clockwise
(when viewed from outside). Place lock
cam onto lock spindle with the tang
pointing downwards, fit latch lever over
lock cam in orientation shown (Figure 14)
and secure using self tapping screw and washer.
4
Attach top and left-hand side latches as per door fitting instructions and
attach cables to hooks on latch lever in configuration shown (Figure 14).
Latch cable lengths must be adjusted to give approximately 6mm
engagement of latch pins (Figure 15).
•
Figure 17
Latch pin
Latch plate
Nominal 6mm
Engagement
•
Figure 15
Fix here
Fix here
Hole level
with lower hook
Stiffener configuration may var y
•
Figure 16
5
Attach triangular gusset plate to stiffener situated
to the right of the latch lever (Figure 16). The
gusset must be located with the lower 8mm
diameter hole level with the lowest hook on the
latch lever (Figure 16). Fix gusset to stiffener using
2 off No. 10
×
1
/
2
" self tapping screws provided.
(Drill holes 3.5mm diameter).
6
Attach cable adjuster through lower 8mm hole in
corner gusset ensuring threaded end of adjuster
is pointing towards latch lever and is screwed
completely into adjuster block (Figure 17).
NOTE:
Highest hole on corner gusset should be
kept available for exterior release system. The
exterior release system is available from
Cardale as an accessory.