10
NOTE:
LATCH RELEASE CABLE
To avoid kinking the latch release during
packaging/transit, the outer sheath of the cable
is now supplied as a separate item in the kit box
(item 14).
Prior to fitting the latch release cable (Section 4
in the fitting instructions) you simply need to
slide the outer sheath over the cable that is
already attached to the Autoglide unit then
proceed as per the fitting instructions.
1
Ensure manual lever is still disengaged and
fully close door. Ensure drive carriage is pushed
as far down as it will go i.e. with cam pin at top
of slot. (Figure 12).
2
Fit tilt bracket to door (Figure 13) 19mm
(
3
/
4
") above plastic roller on tilt pin with
drive carriage still fully down.
NOTE:
Use the No 8
×
3
/
4
" countersunk
screw in bottom hole and the
No. 10
×
3
/
4
" pan head in the top hole
(Figure 13) use 3.5mm diameter drill.
4
Fitting the latches
Plastic
roller
Drive
carriage
CAM PIN
AT TOP
OF SLOT
Fully
down
•
Figure 12
Tilt bracket
Tilt pin
Drive
carriage
Cam
pin
Fully
down
Plastic
roller
Countersunk screw
19 mm
•
Figure 13
To side
latch
To top
hatch
Latch lever
•
Figure 14