67
Initialize the Proximity Switches
1.
Click the yellow Initialize Machine button. See
Figure 13
-
4
. This activates the homing sequence
and your machine will do the following:
The Z-Axis will move up (the positive direction) until the
Z-Axis proximity switch is engaged. The Z-Axis will then
back off slightly before re-engaging the switch and then
backing off for a final time and setting the Z-Axis to
machine origin.
The X- and Y-Axis will begin to move. The X-Axis will move
to the right (the positive direction) and the Y-Axis will
move to the back (the positive direction).
The X- and Y-Axis will continue to move until one of their
switches is triggered, at which time they will follow the
same pattern as the Z-Axis: engage the homing switch, back off, re-engage, and then back off again.
2.
When all three axes have homed, your router will be in the back-right corner.
Troubleshooting Homing Issues:
docs.carbide3d.com/software-faq/home-switch-troubleshooting
Run the Test Project
Required Components
See
Figure 14-1
:
Item
Description
Qty
A
Permanent Marker
1
B
Large Zip Tie
2
C
Letter-Sized, A4, Paper (not included)
1
D
Masking Tape (not included)
1
E
Piece of Cardboard (not included)
1
Complete the Test Project
To complete this test project (see
Figure 14
-
2
) on your
Shapeoko XXL, follow the project instructions at:
docs.carbide3d.com/tutorials/hello-world
.
Figure 13-4
Figure 14-1
NOTE:
We recommend you use the test project as a
practice run before moving on to cutting projects.
Figure 14-2
Summary of Contents for SHAPEOKO XXL
