Parts List
A
1
16
16
1
16
2
B
C
D
E
F
G
H
1
1
CAPTIVA
70" X 40" DINING TABLE
Step 2
Attach the leg connector bracket (C) to the table legs by inserting bolts (D) with metal washers (E)
through the pre-drilled holes in the leg connector bracket and into the legs.
Step 3
Using the hex wrench (G), tighten all bolts completely and cover them with plastic bolt
caps (F).
IMPORTANT NOTE: Each bolt should be tightened a few revolutions at a time, alternating
between bolts in a cross corner ″X″ pattern. This will ensure your table is level by placing equal
pressure o
n
all bolt joints. Do not over tighten.
Step 4
Keep touch-up paint (H) for future use for both your table and chairs.
Your table is now ready for use.
With the help of another person, turn the table in the upright position.
IMPORTANT:
To avoid damage to your table:
- An umbrella base must be used at all times.
- Make sure the umbrella safety ring is installed in the center of the table before you
insert the umbrella pole through the table.
- Remove the umbrella from the table when not in use or in the event of wind, rain, hail, sleet, snow or
any other inclement weather.
- In storing patio furniture, do not stack anything on glass, stone, or marble tabletops.
- Before storing, drain all water that may have accumulated in or around table frame. If not drained properly,
water can cause freeze damage.
- Cover furniture with outdoor furniture covers when not in use.
- For safety reasons, do not sit or stand on the table.
TABLE TOP
TABLE LEG
LEG
CONNECTOR
BRACKET
BOLT (M6x20)
METAL
WASHER
PLASTIC
BOLT CAP
HEX
WRENCH
TOUCH-UP
PAINT
Step 1
With the help of another person, turn the table top (A) upside down on a soft surface
.
Attach table
legs (B) to the table top by inserting bolts (D) with metal washers (E) through the pre-drilled holes
in the legs and into the table top. (DO NOT TIGHTEN THE BOLTS COMPLETELY)
Step 1
Step 2
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective
materials, place parts on a nonabrasive surface to avoid scratching. If any parts
are missing or damaged, DO NOT attempt to assemble. Please contact our
customer service center (Monday-Friday 9:00 a.m.-5:00 p.m.CST) at
1-877-527-0313 or visit our website at www.homedepot.com.
HM-7040T05