CapstanAG PinPoint III ENVELOP, Operator'S Manual

Page: 53 / 128

TM
Operation
NH3 Settings Menu Descriptions
NH3 Settings Screen
Line Title Line
Number
Description
Strainer Pressure 1
This value is comparing the static inlet pressure to operating inlet pressure and if the
pressure drops too much, a message will show.
Min Outlet Pressure 2
If the outlet pressure is below this value, a message will show.
NH3 Cooler 3
Select Enable if the system is equipped with an NH3 cooler.
Initial Setup Settings Descriptions
Configuration
Line Title Line
Number
Description
Task Controller Mode
Select the rate control mode for your system:
External Rate Rate and sections are controlled by an external rate controller.
Internal Rate The PinPoint
™
system controls rate, sections are externally controlled.
1
ISO The task controller supplies the target rate and section control up to
individual nozzle control. The PinPoint
™
system controls the rate.
Fluid Control Mode
Select the fluid control mode for your system:
2
SharpShooter If in External Rate mode, the rate controller controls the pump and the
PinPoint
™
system controls the nozzles to a target pressure.
If in Internal Rate or ISO mode, the PinPoint
™
system controls the
pulsing nozzles and the pump.
©
2021 Capstan Ag Systems, Inc.
53
PinPoint
™
III ENVELOP