CapstanAG PinPoint III ENVELOP, Operator'S Manual

Page: 34 / 128

TM
Initial System Setup
System Wet Tests
Do these procedures to make sure that the soft boom and nozzle valves are operating correctly.
Boom Shutoff Wet Test
1. Fill the sprayer with approximately 400 gallons of water.
2. Make sure that the VT display and rate controller are off.
3. Start the machine engine and set to idle speed.
4. Turn on the VT display and rate controller.
Figure 24:
5. Select the box (1) below speed (2).
6. Set a test speed (3).
7. Select the box (4) below rate (5).
8. Select M (6) and then use the arrow icons (7) to change the rate.
9. Select the box (8) below pressure.
10. Select M (9) and then use the arrow icons (10) to change the pressure.
11. Select the box (11) below System.
12. Select the box (12) next to Pump (13) until ON shows.
13. Make sure that the system is controlling the pressure.
14. Turn on all of the boom switches.
All of the nozzle valves on the boom should start to spray.
15. Turn off all of the boom sections.
©
2021 Capstan Ag Systems, Inc.
34
PinPoint
™
III ENVELOP