CapstanAG PinPoint III ENVELOP, Operator'S Manual

Page: 32 / 128

TM
Initial System Setup
System Dry Tests
Do these procedures to make sure that the soft boom and nozzle valves are operating correctly.
Boom Shutoff Dry Test
1. Make sure that the engine is off and the key is on.
2. Turn on the VT display at the rate controller.
Figure 21:
3. Select the box (1) below speed (2).
4. Set a test speed (3).
5. Select the box (4) below rate (5).
6. Select M (6) and then use the arrow icons (7) to change the rate.
7. Turn on all boom switches.
8. Turn on the master switch.
All nozzles valves should start clicking.
9. Turn off all of the boom sections.
10. Turn on boom section 1.
11. Make sure the nozzle valves for the correct boom section are clicking.
12. Turn off boom section 1.
13. Repeat steps 9 to 11 for each boom section.
14. Turn off the master switch.
©
2021 Capstan Ag Systems, Inc.
32
PinPoint
™
III ENVELOP