Step 1:
Remove the visor clip and the shield from
the bag.
CapShields Instructions
Step 2:
Remove the protective plastic from one side
of the shield.
This will be the inside of the
shield when in place.
NOTE
:
When done properly, there
should be no gaps between
the shield and the clip.
Step 3:
Making sure the clip is held so the printing is at the top and starting at one end of the clip, insert the post into the end hole of
the shield.
3.1:
Make sure the inside of the shield has the protective sheet
removed and the protective sheet remains on the outside.
Do not remove the outside protective sheet yet.
3.2:
Work your way around the front of the clip, progressively inset the posts until they are all inserted into the holes.
The holes are intentionally elongated so be sure to pull the shield as you work your way around so it does not slip off the post.
3.3:
Smooth out the face shield so it sits firmly on the front edge of the visor clip.
3.4:
You should now have the shield attached to the clip with the printing on the top.
3.4
3.3
Print at
top of clip
3.2
3.1
CAP
TM
