CAPITAL SPORTS 10026913, Manual

Page: 46 / 70

46
Troubleshooting
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off auto-
matically to prevent any injuries to the user and to prevent damage to the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power switch off, waiting
for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-checking analyse
(please refer to Self-Checking) to distinguish what type of error problem the machine is encountering.
Error Cause and Solution
E0
No feedback from controller or speed sensor
1. Check the condition of cables and ensure that all plugs are connected between
the motor controller and display.
2. Check that the speed sensor and magnet are in correct alignment and that
there are no obstructions on the magnet. (The magnet can be found on the
front roller near the motor belt).
3. If the running belt moves then displays the E1 error after 10 seconds, replace
the speed sensor.
4. If the running belt does not move, replace the controller.
E1
Self-checking failuret
1. If the running belt does not move, replace the controller.
2. Ensure that all plugs are connected between the motor controller and display.
3. Check that the speed sensor and magnet are in correct alignment and that
there are no obstructions on the magnet. (The magnet can be found on the
front roller near the motor belt).
E3
Self-checking failure
1. If the running belt does not move, replace the controller.
2. Ensure that all plugs are connected between the motor controller and display.
3. Check that the speed sensor and magnet are in correct alignment and that
there are no obstructions on the magnet. (The magnet can be found on the
front roller near the motor belt).
No Power
1. Check fuses (They are located on the controller under the motor cover).
2. Check power outlet (Plug something else into the power outlet to ensure that
the power outlet is working correctly).
3. Check Power Cable (You may need to take it to an electrician).