Capetti Elettronica WSD12PS-4AI, User Manual, Page: 8 / 12

WSD12PS-4AI
User Manual
PAGE 8
WA0285E_WSD12PS-4AI_User Manual_R06 V6.0
www.
capetti
.it
9. Device enrolment.
Not necessary if performed in factory before delivery.
Enrol the device to the network referring to the
“ WineCap System - User Manual R30 ”
. In case the device is already enrolled but in STANDBY status, a
TEST command must be issued (
refer to Picture 7 - Command table
)
.
10. Installation procedure.
After installing the gateway in appropriate place in charge, (
refer to
“
WineCap System - User Manual R30
”), be sure that the device is enrolled to the
gateway and activated.
Head for the environment to be monitored. On the way, to check the quality of the radio coverage, use the "Field Measurer" function.
This function is activated issuing the TEST
(
refer to Picture 7 - Command table
)
command: position the
WineCapKey
in the spot indicated in
Picture 6 -
WineCapKey positioning
and wait for two AMBER flashes, then remove the
WineCapKey
from device. The "Field Measurer" function lasts enabled for
two minutes.
To issue commands to the device, place the
WineCapKey
where indicated.
Once the
WineCapKey
, is detected, the led periodically emits AMBER flashes with a 2 second cadence.
For each flash, a different command is associated; to confirm the command the
WineCapKey
must be removed from the sensible area immediately
after the number of flashes corresponding at the desired command. The TEST corresponds to the second pulse and activate the "Field Measurer"
function.
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
FLASH COUNT – WIRELESS MODE STATUS/RADIO SIGNAL QUALITY
5 green flashes ACTIVE - Radio signal: Excellent
4 green flashes ACTIVE - Radio signal: Good
3 green flashes ACTIVE - Radio signal: Fair
2 amber flashes ACTIVE - Radio signal: Sufficient
1 red flash ACTIVE - Radio signal: Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long
STANDBY
Radio off - No Logging
Short-long-short red
flashes series
FACTORY RESET
Device not enrolled
– No logging
Picture 8 - Status table - Radio signal quality
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a
repeater WR12
should be put between (
refer to
“
WineCap System - User Manual R30
”). The
repeater
WR12
itself must be in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the
repeater WR12
.
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force the operation.
In such cases, put the device in STANDBY mode, then run the TEST again (
refer to
“
WineCap System - User Manual R30
”).
NOTE: The display equipped datalogger
(
WD04T
)
is recommended, to verify the signal quality during devices installation.
11. Stand-alone USB datalogger installation.
Install the datalogger in appropriate place.
If the sampling process has not yet been activated, you can start it through the
WineCapKey
.
Bring it closer to the sensitive point, wait for 2 flashes (
TEST
)
(
refer to Picture 7 - Command table
)
and remove. The datalogger begins sampling
according to your settings through your PC.
Through the
WineCapKey
is possible to ask for the status, bring it close to the datalogger for 1 flash (
STATUS
) and remove it.