Capetti Elettronica WSD12PS-4AI, User Manual, Page: 9 / 12

WSD12PS-4AI
User Manual
PAGE 9
WA0285E_WSD12PS-4AI_User Manual_R06 V6.0
www.
capetti
.it
STAND-ALONE DEVICE - STATUS TABLE Table
FLASH COUNT – STAND ALONE MODE STATUS
1 green flash 2 seconds long ACTIVE
2 red flashes 2 seconds long STANDBY
Sequence of red flashes: short,
2 seconds long, short
FACTORY RESET
INVALID datalogger clock!
PC connection required.
Picture 9 - Stand-alone device - Status table
12. Shutting off/Reactivating the device.
If the device is shut off and left unused for a long time, you can issue the STANDBY command (
refer to Picture 7 - Command table
) . It corresponds to
the command number 4 and must be issued twice to confirm the operation.
Position the
WineCapKey
in the spot indicated in (
Picture 6 - WineCapKey positioning
), and wait for four AMBER flashes, then remove the
WineCapKey
from
device. Verify that the device asks for confirmation of STANDBY command with alternate GREEN/RED flashing, then position again the
WineCapKey
and wait for four flashes again. The device will confirm the STANDBY status lighting the RED led for 2 seconds twice. To reactivate the device
the TEST command must be issued.
13. Transducer’s connection layout .
Picture 10 - Connections layout