WA0123E_WSD00T/WSD00T_LD_User Manual_R10
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail [email protected] - web www.capetti.it
5/8
WSD00T / WSD00T_LD
User Manual
6.
Stand-alone USB datalogger installation.
Install the
datalogger
in appropriate place.
If the sampling process has not yet been activated you can start it through the
WineCapKey
.
Bring it closer to the sensitive point, wait for 2 flashes (
TEST
) and remove. The
datalogger
begins sampling according to your
settings through your PC.
Through the
WineCapKey
is possible to ask for the current status, bring it close to the
datalogger
for 1 flash (
STATE
) and remove it.
STATUS
Table:
Flash count - Stand-alone mode
STATUS
1 green flash 2 seconds long
ACTIVE
2 red flashes 2 seconds long
STANDBY
Sequence of red flashes: short, 2
seconds long, short
FACTORY RESET
INVALID
datalogger
clock!
PC connection required
7.
Shutting off/Reactivating the device.
If the device is shut off and left unused for a long time, you can issue the
STANDBY
command. Its corresponds to the command
number 4 and must be issued twice to confirm the operation.
Position the
WineCapKey
in the spot indicated in
Picture 3
and wait for four
AMBER
flashes, then remove the
WineCapKey
from
device.
Verify that the device asks for confirmation of
STANDBY
command with alternate
GREEN/RED
flashing, then position again the
WineCapKey
and wait for four flashes again. The device will confirm the
STANDBY
status lighting the
RED
led for 2 seconds twice.
To reactivate the device the
TEST
command must be issued.
Picture 6 - Stand-alone datalogger status