CDE360 Vector Control AC Drive Chapter 5 Parameter List Table
-
54
-
Code
Name
Range
Default
Step
Description
b2.01
Preset Frequency
0.00~b0.00
50.00
0.01Hz
b2.02
①
Auxiliary frequency source B
0~8
0
1
Same As b2.00
b2.03
Range of auxiliary frequency
source B
0~100
100
1%
b2.04
Offset frequency for A and B
operation
0.00~b0.00
0.00
0.01Hz
b2.05
Frequency source selection
00~34
00
1
Unit's digit (Frequency source selection)
0: Main frequency source A
1: A and B operation
(operation relationship determined by ten's digit)
2: Switchover between A and B
3: Switchover between A and "A and B operation"
4: Switchover between B and "A and B operation"
Ten's digit (A and B operation relationship)
0: A+B
1: A-B
2: min{A,B}
3: max{A,B}
b2.06
Binding command source to
frequency source
000~999
000
1
Unit's digit (Binding the frequency source together with Keypad control source)
0: No binding
1: b2.01+UP/DOWN
2: AI1
3: AI2
4: AI3
5: X6/FI
6: Multi-reference
7: PLC
8: PID
9: Communication
Ten's digit (Binding the frequency source together with Terminal control source)
Hundred's digit (Binding the frequency source together with Communication control source)
b2.07
①
Frequency resolution
1~2
2
1
1: 0.1Hz 2: 0.01Hz
All the parameters with
‘Hz’ unit will change following b2.07. Such as b0.09(50.00Hz) will change to
500.0Hz when set b2.07 from 1 to 2.
C0 Digital Input
Function
Code
Name
Range
Default
Step
Description
C0.00
X terminals filter time
0.000~1.000
0.010
0.001Sec
C0.01
①
X1 function
0~58
3
1
0: No function
1: Forward JOG(FJOG)
2: Reverse JOG(RJOG)
3: Forward RUN (FWD)
4: Reverse RUN (REV)
5: Three-line control
6: RUN pause
7: Coast to stop
8: External STOP terminal 1
9: External STOP terminal 2
10: Emergency Stop
11: Immediate DC braking
12: Deceleration DC braking
13: Terminal UP
14: Terminal DOWN
15: UP and DOWN setting clear
(terminal, operation panel)
16: Multi-reference terminal 1
17: Multi-reference terminal 2
18: Multi-reference terminal 3
19: Multi-reference terminal 4
20: Terminal 1 for Acceleration
/deceleration time selection
21: Terminal 2 for Acceleration
/deceleration time selection
22: Acceleration/Deceleration
prohibited
23: Fault reset
24: Normally open (NO) input of
external fault
