Cannot Detect the Machine during Wireless LAN Setup: Check 3
Is the machine connected to the access point?
By using the operation panel of the machine, make sure that the machine is connected to the access
point.
Select
Setup
on the
HOME
screen, then select
Device settings
>
LAN settings
>
Confirm LAN
settings
>
WLAN setting list
.
Make sure that
Connection
on the LCD is set to
Active
.
If Connection is set to Inactive:
The machine may be placed far away from the access point. Place the machine near the access point
temporarily, then click
Redetect
on the
Check Printer Settings
screen.
When the machine is detected, follow the instructions on the screen to continue to set up the network
communication.
If the machine cannot be detected, the machine is not connected to the access point. Connect the
machine to the access point.
Click
Back to Top
on the
Check Printer Settings
screen to try to set up the network communication from
the beginning.
If Connection is set to Active:
Go to check 4.
Cannot Detect the Machine during Wireless LAN Setup: Check 4
733
Summary of Contents for MG5600 series
