Canon Z5000, Configuration Manual

Page: 85 / 168

4
4-1 Accessing Setup
After you have performed initial Setup (Server, Network and Printer Setup) from the
Control Panel, you can change most Setup options from a Windows computer.
Accessing Setup
In addition to using the Control Panel, you can set up the ColorPASS two ways:
locally and remotely. Local Setup is for systems with the Advanced Controller
Interface. Local Setup uses a Windows NT application, Fiery Server Setup. Remote
Setup is performed from a Windows computer using the Command WorkStation.
N
OTE
:
In this chapter, illustrations for both Setup interfaces, where applicable, appear
side by side: local Setup on the left, remote Setup on the right. Some Setup options
cannot be accessed from remote Setup; use local Setup or the ColorPASS Control
Panel instead.
Regardless of how you access Setup, you must log in as Administrator, both at the
ColorPASS and within the Setup application you use. After the ColorPASS is
rebooted, log in at the Windows NT Logon window with Administrator as the login
name and the password if required. This login and password are the Windows NT
login and password.
To use the Command WorkStation, you must enter the ColorPASS Administrator
password. This is set either from the Control Panel or the Command WorkStation.
See Getting Started for information on the Command WorkStation system
requirements and installation instructions.
Chapter 4:
Setting up the
ColorPASS from
a Windows
Computer