S
etting the Time Code
72
3 After completing all the fields of the time code, select [OK].
• Select [Cancel] to close the screen without changing the time code.
• If the running mode is set to [
Free Run], the time code will start running from the time code entered
the moment you select [OK].
4 Select [
X
].
Selecting Drop Frame or Non-Drop Frame
You can select between a drop frame (DF) or non-drop frame (NDF) time code, depending on how you plan to
use your recordings. However, when the frame rate is set to 23.98P, the time code is set to non-drop frame
(NDF) and cannot be changed.
1
S
elect [DF/NDF].
>
[
3
#
Recording Setup]
>
[DF/NDF]
2
S
elect [
DF] or [
NDF] and then
s
elect [
X
].
• The time code display will differ depending on the setting. When you select [
DF], the time code will
appear as [00:00:00.00]; when you select [
NDF], it will appear as [00:00:00:00].
NOTES
NOTES
• When the frame rate is set to 23.98P, the frames value in the time code runs from 0 to 23. For other settings, it
runs from 0 to 29.
• When slow & fast motion recording is activated, you cannot select the [
Free Run] running mode.
Conversely, when pre-recording is activated, [
Free Run] is set automatically and cannot be changed.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• When slow & fast motion recording is activated, the time code signal cannot be output from the SDI OUT
terminal (
z
only) or HDMI OUT terminal.
• When you are using the [
Free Run] running mode, the time code will continue running as long as the
built-in backup battery has some charge left, even if you disconnect all other power sources. However, this is
less accurate than when the camcorder is on.
Overlaying the Time Code/Date/Time on the Recorded Image
You can overlay the time code/date/time on the image and record it with the recorded clips. You can also select
the overlay's position on the screen (
A
1
S
elect the data to be di
s
played.
>
[
3
Recording Setup]
>
[OSD Recording]
>
Desired option.
2
S
elect the po
s
ition of the
s
elected data.
>
[
3
Recording Setup]
>
[OSD Recording Position]
>
Desired option.
• Once set,
will be displayed.
NOTES
NOTES
• Noise levels may rise on the image.
• Recorded photos are not affected.
• When a custom picture file is enabled, the [
/
Custom Picture]
>
[Noise Reduction]
>
[Frame Correlation]
setting is not available.
• This setting cannot be used when slow & fast motion recording is activated.
• This setting cannot be used in MEDIA mode.
Summary of Contents for XA70
