Completing Projector Settings
167
Inst
alla
tio
n
an
d Main
te
na
nce
Con
necting
to a Networ
k
Registering a Network
Password
> [Network settings] >
[Register
network password]
Register the projector network
password.
When [Register network password] is
selected, the window shown below
appears.
Enter a 4-digit password.
Enter the password using the [ ] / [ ] /
[ ] / [ ] buttons on the remote control.
Press the
OK
button to accept your
setting and then press the
MENU
button.
• If you forget the password, press [ ] [OK]
[ ] [OK] [ ] [OK] to restore the factory
default setting.
• The factory default is [ ] [ ] [ ] [ ].
Specifying Standby
Power Consumption
> [Network settings] >
[Network
standby settings]
Specify network function operating
status in standby mode as follows.
Press the
OK
button to accept your
setting and then press the
MENU
button.
• [Low-power] is the factory default.
• [Low-power] may delay access over the
network for some functions. For faster
access, select [Normal].
• Power consumption when [Network function
(wired)] is [On] varies depending on
whether [Network standby settings] is set to
[Normal] or [Low-power].
Normal
All network functions are available
even in standby mode, including
the web screen, control over the
network, and PJLink.
Low-
power
All network functions are available
even in standby mode.
However, the projector may be
less responsive than usual when
some functions are initially used.