WUX500ST
User Commands
-43-
DZOOM_POS
Zoom display position
Format
Setting
Command
DZOOM_POS=<DZOOM position X:Number>,<DZOOM position
Y:Number>
Response
i:OK
Reference
Command
GET= DZOOM_POS
Response
g:DZOOM_POS=<DZOOM position X:Number>,<DZOOM position
Y:Number>
Note: See "Error list" for any response other than the above.
<DZOOM position X/Y:Number> is a signed integer indicating the central position of the enlarged input
image.
Environment
Power mode restriction
Input
LAN
WiFi
RS-232C
SL0 SL1 SL3 PM ON SL0 SL1 SL3 PM ON ST PM ON D-RGB A-RGB COMP HDMI HDBT LAN USB
No
signal
No No No No Yes No No No No Yes No No Yes
Yes
Yes
Yes
Yes
Yes Yes Yes
No
Remarks
(1) This command is identical to pressing the arrow keys to move while DZOOM is enabled, however,
the position can be specified in more detail.
(2) If a position outside the range is specified, the position is automatically moved to the nearest
position within the range.
(3) 0 for <DZOOM position X/Y:Number> indicates the center position of the input image.
(4) Positive direction for <DZOOM position X/Y:Number> corresponds to RIGHT and UP keys, and
negative direction corresponds to LEFT and DOWN keys.
(5) The numerical value for <DZOOM position X/Y:Number> represents units in pixels of the input
image.
* For example, in a case where an input image of XGA (1024 x 768) size is enlarged twice the size
(range of 512 x 384 is displayed),!!!REMOVE BREAK!!!
up to ±256 for <DZOOM position X:Number>, and up to ±192 for <DZOOM position Y:Number>
can be specified.
Example
(Control)
> DZOOM_POS=100,200
< i:OK
(Reference)
> GET=DZOOM_POS
< g:DZOOM_POS=100,200
Note: '>' indicates a command; '<' indicates a response.
