Canon W6400 Series, Service Manual

Page: 93 / 196

Chapter 4
4-3
4.3 Points to Note on Disassembly and Reassembly
4.3.1 Note on locations prohibited from disassembly
0009-8782
Locations that are prohibited from disassembly and cannot be adjusted outside of the factory have red screws instead of the regular-colored screws.
However, note that the color has been changed from the previous red screws.
F-4-3
4.3.2 Manual carriage movement
0009-8783
The carriage is moved by holding down the button or button on the operation panel for at least 0.5 seconds when the printer is offline. However,
when the power is turned off such as during assembly or disassembly, move the carriage by holding the knobs shown in the figure below.
Move the carriage as required during assembly and disassembly to prevent contact of the carriage with the parts that are removed.
The carriage does not move when capping has been performed. Refer to the procedures in DISASSEMBLY/REASSEMBLY > Points to Note on
Disassembly and Reassembly > Opening the Caps and Moving the Wiper Unit to remove the caps and move the carriage.
F-4-4
<New Do Not Disassemble red screw> <Previous Do Not Disassemble red screw>
Knob
Knob