1-41
1
1
D
etailed Settings
IPsec Settings (IPsec)
IPsec Set
IPsec Sets 1 to 5 are available, where IPsec settings for each communication using each IPsec
Set.
(1) [IPsec]
Select [
Manual
] if IPsec will be used. Select [
Disable
] if IPsec will not be used.
(2) [IPsec Mode]
Select [
Tunnel Mode
] or [
Transport Mode
] as the IPsec operation mode.
(3) [Destination Address (IPv4/IPv6)]
Enter the IP address of the connection destination.
(4) [Source Address (IPv4/IPv6)]
Enter the IP address of the sender.
(5) [Security Protocol]
Select [
ESP
], [
AH
] or [
ESP and AH
] as the IPsec protocol to be used.
If [
ESP
] is selected, enter only the setting items relating to ESP.
If [
AH
] is selected, enter only the setting items relating to AH.
If [
ESP and AH
] is selected, enter all setting items.
(6) [Security Gateway Address (IPv4/IPv6)]
If the IPsec operation mode was set to [
Tunnel Mode
] in (2), set the IP address of the
security gateway.
(7) [Destination Prefix Length]
This setting is required only when the IPsec operation mode was set to [
Tunnel Mode
] in (2).
Enter a desired prefix length for connection destination in a range of 0 to 128.
If IPv4 is used, enter a desired length in a range of 0 to 32.
You can set the following items.
z
Various settings can be specified for up to five communicating devices.
COP
Y
