Canon Super G3 FAX Board-AR1, Service Manual

Page: 69 / 69

7
7
Installation_Super G3 2nd Line Fax Board-AR1
Installation_Super G3 2nd Line Fax Board-AR1
7-14
7-14
Installation_Super G3 2nd Line Fax Board-AR1 > Operation Setting > FAX Communication Test
Installation_Super G3 2nd Line Fax Board-AR1 > Operation Setting > FAX Communication Test
FAX Communication Test
Perform communication test to check if FAX function works correctly.
1) Switch the control panel display to
[
Fax] display.
2) Select the sending line.
• Press [Fax] > [Options] > [Select Line], select the added line, then press [OK] button.
3) Send and receive a test original between the equipment and a remote unit
with which a communication test can be performed and check if it can be
sent and receive correctly.
• Press [Status Monitor/Cancel] > [Send] > [Job Log] and select [Fax] from pull down menu.
• Press [Comm Report] > [OutPut Normally] > [Start Printing].
• The number printed following colon (:) in "COMM.MODE" field on COMMUNICATION
MANAGEMENT REPORT TX/RX shows line type used for sending/receiving.
E.g. "ECM:2" => Line 2