Canon Staple Finisher-AA1, Service Manual

Page: 113 / 228

Removing the Saddle Unit
■ Preparation
1. Pull out the saddle unit (service position).
“ Pulling Out the Saddle Unit (Service Position)” on page
131
2. Remove the lower front cover.
“ Removing the Lower Front Cover” on page 94
■ Procedure
1. Remove the saddle PCB cover [1].
• 2 screws [2]
2x
[2] [1]
2. Remove the harness.
• 2 connectors [1]
• 2 wire saddles [2]
• 1screws [3]
1x
2x
[3]
[2]
[1]
[1]
2x
3. Remove the saddle unit [1].
• 2 screws [2]
• 4 hangers [3]
[3]
[3]
[2]
[2]
[1]
[3]
[3]
2x
CAUTION:
Hold specific parts to remove the Saddle Unit as shown
in the figure or there is a possibility of breakage when
holding other parts.
NOTE:
Since the saddle unit is not stored due to come in contact
with the front cover. When installing the saddle unit, be
sure to open the front cover.
4. Parts Replacement and Cleaning
105