Canon Stacker-C1, User Manual

Page: 29 / 40

3-2 Error Messages
T
roubleshooting
3
Error Messages
When an error occurs and the machine does not work properly, the following screen will be
shown. If the screen indicates the “SERVICE CALL ERROR”, perform as follows:
Service Call Error
When SERVICE CALL ERROR is shown on the LCD, turn off the power switch of the stacker
and the upstream machine (printer). Wait about 10 seconds, and turn on the power switch of the
stacker and then turn on the power switch of the upstream machine (printer) again. If the SER-
VICE CALL ERROR is still shown on the LCD, check the following items, turn off the main power,
and disconnect the power plug. Then contact your local authorized dealer.
- Product Name
- State of trouble
- Code number indicated on the screen
Do not plug in and out the power plug by wet hand.
It causes electrical shock.
When you plug out the power plug, be sure to hold
the plug. If you pull the power cable, it may expose
or cut the core wires and cause a leak of electricity,
and result in fire or electrical shock.
WARNING
CAUTION