Canon Saddle Finisher-T2, Service Manual

Page: 137 / 262

Chapter 3
3-35
F-3-138
7) Disconnect two connectors [1] and remove harness
from the clamp and edge saddle [2].
8) Remove two screws [3] and pull out the processing
tray [4] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-3-139
3.3.2 Tray 1
3.3.2.1 Removing the Front
Door
0009-4456
1) Open the front door [1] and remove the clip [2].
2) Lift the front door [1] to remove.
F-3-140
3.3.2.2
Removing the Rear
Upper Cover
0009-3586
1) Remove four screws [1] and remove the rear upper
cover [2].
F-3-141
3.3.2.3 Removing the Escape
Tray Cover
0009-4426
1) Remove four screws [1], open the escape door [2],
and then remove the escape tray cover [3].
[2]
[3] [4] [5] [1]
[4]
[3] [3]
[2]
[1]
[1]
[2]
[1]
[2]
[1]