Canon Saddle Finisher-AF2, Service Manual

Page: 35 / 244

Chapter 2
2-9
F-2-25
2.3.5 Connecting with the Multi Drawer Document
Insertion Unit
0020-6007
1) Remove 2 screws [1] from Multi Insertion Unit upper left side.
(The removed screws are not in use anymore).
F-2-26
2) Install the latch support (front) [1] (back) [2] in the left side of the Multi
Insertion Unit.
- 4 screws (RS tightening ; M4X10) [3].
F-2-27
3) Fit the positioning pin [1].
- 2 screws (RS tightening; M4X10) [2]
F-2-28
4) While lifting latch mount (front) [1], fit the Multi Insertion Unit side's po-
sitioning pin [2] into the positioning board's hole of the Finisher [3], to
connect the Finisher with the Multi Insertion Unit.
<Front side>
CAUTION:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
CAUTION:
Confirm the engraved mark on each latch plate when attaching.
For front [1]: F
For rear [2]: R
[1] [2]
[2]
[1]
[1]
R
F
[2]
[3] [1]
[3]
[2]
[1]
[2]
[1]