Canon Saddle Finisher-AF2, Service Manual

Page: 164 / 244

Chapter 5
5-2
5.3 Adjustment
5.3.1 Basic Adjustment
5.3.1.1 Height Adjustment
0021-1701
In the case of jam with this equipment, follow the steps below to execute
height adjustment.
1. Checking the height
1) Check height between the finisher and the host machine. Check whether
the height difference between the upper right surface [1] of the finisher
and the upper left surface [2] of the host machine is /- 2mm.
F-5-1
2) If the height difference is +/- 2mm or more, execute height adjustment.
2. Height adjustment
1) Separate the finisher from the host machine.
2) Remove the spanner [1] from the front cover.
- 1 screw [2]
F-5-2
3) In the case of finisher, remove the caster cover [1] at the front.
- 1 screw [2]
F-5-3
4) In the case of saddle finisher, remove the saddle inner cover (lower) [1].
- 1 screw [2]
- 1 knob [3]
- 3 screws [4]
F-5-4
5) Remove the 2 caster covers [1] at the left side. (the illustration shows in
the case of the saddle finisher)
- 2 screws [2]
MEMO:
Use 4 casters [1] shown in the figure for height adjustment.
[1] [2]
[1]
[1]
[1]
[2]
[1]
[2]
[1]
[2] [3]
[4]
[4]