1
1
1-3
1-3
Specifications > Specifications > Receive Function > Receiving:
Specifications > Specifications > Receive Function > Receiving:
Specifications
Send Function
Sending:
Using the PCFAX system, you can send fax image data from the unit on which the Remote
Fax Kit is activated to a unit with a fax board.
The unit with a fax board sends faxes to the destination by standard fax operation via the
telephone line.
Once the Remote Fax Kit is activated, configure the settings for connecting to the another
unit (with a fax board).
On the another unit (with a fax board), set the [Use Remote Fax] setting to [On].
Receive Function
Receiving:
Use the following procedure to receive faxes on the unit without a fax board.
Perform receiving/forwarding from the unit with a fax board (imageRUNNER ADVANCE or
conventional model).
[iFAX function] -> unit on the same network (imageRUNNER ADVANCE or conventional
model).
Using the receive/forward setting on the unit with a fax board, specify the unit with the
activated Remote Fax Kit.
■
•
•
■
•
F-1-1
F-1-1
Important
If only the receiving function is needed, an iR unitwith iFAX functionality can be used.
In the case that Remote FAX sends result to FAX when reception completes (Full Mode
function) and performs communication without a mail server, Direct MDN is required.
In the case of performing communication via a mail server without need of sending
result, Direct MDN is not required.
It is supported from iR C5180/4580/3880 Series or later series.
When specifying address using IP address format, it is necessary to put an IP address
in brackets like 123@[172.16.1.100].
F-1-2
F-1-2
