Canon Pixma PRO-100S series, Online Manual

Page: 182 / 617

Changing the Printer Operation Mode
If necessary, switch between various modes of printer operation.
The procedure for configuring Custom Settings is as follows:
Custom Settings
1. Open the printer driver setup window
2. Make sure that the printer is on, and then click Custom Settings on the Maintenance
tab
The Custom Settings dialog box opens.
Note
• If the printer is off or if communication between the printer and the computer is disabled, an
error message may appear because the computer cannot collect the printer status.
If this happens, click
OK to display the most recent settings specified on your computer.
3. If necessary, complete the following settings:
Detects a printable disc in the disc tray
Detects whether a printable disc is loaded on the disc tray during disc label printing and displays a
message if a disc is not loaded.
Check this check box to print with detecting whether a printable disc is loaded.
Uncheck this check box to print without detecting whether a printable disc is loaded.
Important
• If you leave this check box unchecked, the printer may print to the disc tray even if a printable
disc is not loaded on the disc tray. Therefore, you should check this check box under normal
circumstances.
• If you load a printable disc that has already been printed onto the disc tray, the printer may
detect that no printable disc is loaded on the disc tray. In this case, uncheck this check box.
Prevent paper abrasion
The printer can increase the gap between the print head and the paper during high-density
printing to prevent paper abrasion.
Check this check box to prevent paper abrasion.
Align heads manually
Usually, the Print Head Alignment function on the Maintenance tab is set to automatic head
alignment, but you can change it to manual head alignment.
If the printing results of automatic print head alignment are not satisfactory,
perform manual head
alignment .
Check this check box to perform the manual head alignment. Uncheck this check box to perform
the automatic head alignment.
Detect paper width
Detects the width of paper loaded in the printer when printing.
When the paper width detected by the printer is narrower than the width of the paper specified in
182