74
Troubleshooting
LCD Cannot Be Seen At All
An Unintended Language Is Displayed on the LCD
Cannot Install the MP Drivers
Cause
Action
Cannot see the display on the LCD.
z
If the
POWER
lamp is off
The machine is not powered on. Connect the power cord and press the
ON/
OFF
button. The machine will power on and the LCD will display a message.
z
If the
POWER
lamp is lit
The LCD may be in the screen-saver mode. On the Operation Panel, press a
button other than the
ON/OFF
button.
Cause
Action
The language you want to be displayed
is not selected.
Select the language you want to be displayed according to the following
procedure.
(1)
Press the
HOME
button. Wait for about 5 seconds, select
, and then
press the
OK
button.
(2)
Press the
]
button to select
, then press the
OK
button.
(3)
Press the
}
button four times, then press the
OK
button.
If the Bluetooth unit is connected to the machine, press the
}
button five
times, and then press the
OK
button.
(4)
Press the
{
or
}
button to select the language you want to be displayed,
then press the
OK
button.
Cause
Action
Unable to proceed beyond the
Printer
Connection
screen.
If you were unable to proceed beyond the
Printer Connection
screen, follow
the procedure below to reinstall the MP Drivers.
(1)
Click
Cancel
on the
Printer Connection
screen.
(2)
Click
Start Over
on the
Installation Failure
screen.
(3)
Click
Back
on the screen that appears next.
(4)
Click
Exit
on the
Welcome
screen, then remove the CD-ROM.
(5)
Turn the machine off.
(6)
Restart the computer.
(7)
Make sure you have no application software running, including anti-virus
software.
(8)
Follow the procedure described in the
Easy Setup Instructions
to reinstall the
MP Drivers.