Removing Finished Booklets
2-11
Bas
ic O
p
er
ati
ons
2
Removing Finished Booklets
Use the following procedure to remove bound booklets from the stacker.
CAUTION
Do not do operations other than removing booklets. Putting your hand into the
binder from the stacker may cause an injury.
Take care to avoid cutting your hands on the edges of the booklets when
removing them.
Do not use the stacker as storage. Using the stacker as storage could cause a
malfunction.
IMPORTANT
The cuttings may enter into the stacker. If this happens, remove the cuttings from the
stacker.
NOTE
This operation can be performed while the device is operating.
The stacker can hold booklets up to approximately 5" [127 mm] (equivalent to 10 booklets
of 100 pages of 17 lb bond (64 g/m
2
) body pages/slip sheets and a cover of one 32 lb bond
(128 g/m
2
) sheet) or approximately 1000 sheets of paper as a total. However, if the
booklets contain the body pages/slip sheets that are heavier than 20 lb bond (81 g/m
2
), the
stacker may not be able to hold booklets up to approximately 5" (127 mm).
When the Perfect Binder Continuous Kit is installed, bound booklets are automatically
output to outside the machine.
The stacker has two LED’s: a stack LED and open LED. Each LED indicates the
following.
- Stack LED
Lit:
The finished booklet is stacked in the stacker.
Flashing: Binding operation is in progress.
