Canon Paper Deck-V1, Service Manual

Page: 78 / 90

Chapter 4
4-6
[3] and 2 long screwdrivers [4], respectively.
2) Fix the 4 cable fixing plates [5] in place to the lifter
using 2 screws each.
3) Hook the lifer cable [6] on the 4 pulleys [7] above.
4) Hook the ball of the lifter cable on the 2 front/rear
pulleys [8] of the lifter drive shaft; then, wind it
about 1.5 times along the groove of the pulley.
At this time, be sure to keep the lifter cable taut so that
the long drivers used to keep the lifter are slightly
lifted by the cable.
5) Fix the 2 pulleys [5] in place to the lifter drive shaft
with a set screw [9] (1 pc. each).
6) Fit all removed pulleys to the lifter shaft; then,
measure the height A from the base plate of the
compartment to the top face of the lifter, thus
making sure that the lifter is level.
F-4-9
4.2.2.3
Points to Note When
Mounting the Deck Pikcup
Roller
0009-4911
Front of the Machine (collar [3]; silver-colored)
It has its own direction of rotation [1]; when mounting
the deck pickup roller [2] to the front of the machine,
be sure that the marking [4] found on the collar [3] is
to the front of the machine.
Rear of the Machine (collar [7]; gold-cover)
It has its own direction of rotation [6]; when mounting
the deck pickup roller [6] to the rear of the machine,
be sure that the marking [8] found on the collar [7] is
to the rear of the machine.
F-4-10
4.2.2.4 Points to Note When
Mounting the Deck Pickup/
Feed Roller
0009-4910
When mounting the deck pickup/feed roller [1], be
sure so that the belt pulley [2] is to the front of the
machine.
[4]
[8]
[9]
[5]
[7]
[7]
[1]
[5]
[9]
[8]
[3]
[5]
[6]
[5]
[A]
[A]
[A]
[2]
[A]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]