Canon Paper Deck Unit-B1, Service Manual

Page: 33 / 68

Chapter 3
3-3
F-3-11
6) Insert a hex wrench [3] into the hole of the lifter drive shaft [2] so that it
serves to keep the spindle from turning.
7) Disconnect the power plug.
3.4.3.2 Removing the Deck Lifter Motor (M2D)
0023-7283
1) To prevent deformation of the roll support plate [1], place a stack of paper
[3] (A: about 8 cm) on the floor for the placement of the deck [2].
F-3-12
2) Remove the 3 screws [1], and shift down the right cover [2], then, detach
it toward the front.
F-3-13
Reference:
When mounting the right cover, be sure that the claw [1] on the top of the
right cover is in the hole [2] of the paper deck stay and the right edge [3]
is inside the rear cover [4].
F-3-14
3) Disconnect the connector [1] found at the rear of the compartment, and re-
move the screw [2]; then, detach the harness unit [3].
F-3-15
4) Remove the screw [1] and the stopper plate [2] found at the left rear of the
deck; then, slide the compartment [3] farther out to the front.
F-3-16
5) Remove the 3 screws [2] each from the left/right of the compartment rail
[1]; then, lift the compartment [3] about 1 cm, and detach it to the front.
6) Place the compartment [3] on the stack of paper you have previously pre-
[2]
[1]
[2]
[3]
[3]
[1]
8 cm (approx.)
[1]
[3]
[2]
[3]
[2]
[1]