Canon Oce VarioPrint 6000+ Series, Operation Manual, Page: 44 / 222

Change the warning time
Introduction
When operator interaction is required now or soon, the LED on the operator panel and the
operator attention light can warn you. This is a trigger that action is required now or soon, for
example load a required media type or empty an output location. You can define how long in
advance the warning message is displayed.
By factory default, the function [Warning in advance] is enabled and set to 10 minutes. Then the
dashboard starts to display the warning 10 minutes before an action becomes inevitable. If you
do not respond to the warning message, the printer will stop. Depending on the urgency of the
warning message, the LED on the operator panel and the operator attention light are orange or
red.
NOTE
You can only change the warning time when the [Warning in advance] function is enabled.
[15] Change the warning time
Procedure
1. Touch [System] -> [Setup] -> [Warning time].
2. Touch the - or + button to decrease or increase the warning time in steps of 1 minute. You can set
a time from 1 - 60 minutes.
3. Press [OK].
Change the warning time
44 Chapter 5 - Adapt printer settings to your needs